Boiler Replacement Cost in Dallas, TX
American Standard 4-Ton 18 SEER

The average cost of boiler replacement in Dallas, TX with a American Standard 4.0-ton 18 SEER system is $6,980, with most homeowners paying between $6,630 and $7,320 depending on home conditions, permit fees, and labor availability. The American Standard 4.0-ton unit is a premium, energy-efficient unit engineered for long-term reliability, sized for homes with 1,600-2,100 sq ft of conditioned space. The 18 SEER rating places this unit well above the minimum efficiency standard, reducing annual energy costs significantly.

Cost Breakdown - Dallas, TX

* Estimates based on Dallas area labor rates ($102.72-$166.74/hr, BLS-sourced). Actual costs vary by home conditions and contractor. Get 3 quotes.

About Boiler Replacement

Complete removal and replacement of a residential boiler used for hydronic (hot water or steam radiator) heating systems. In Dallas, TX, licensed HVAC contractors typically charge $103–$167 per hour for installation labor, with this job averaging 10 hours.

The equipment cost for the American Standard 4.0-ton 18 SEER system represents approximately $4,690 of your total. Installation labor in Dallas adds $1,350, with permit fees, refrigerant, and disposal bringing the full estimate to $6,980. Prices in TX vary by contractor — always collect 3 quotes before scheduling a major HVAC installation.

Signs You Need Boiler Replacement

Consider scheduling boiler replacement in Dallas, TX if you notice boiler over 15-20 years old or frequent pressure or leak issues or cold radiators or inconsistent heat. Early action prevents the costly emergency service premiums common in the South region during peak seasons.

• -Boiler over 15-20 years old
• -Frequent pressure or leak issues
• -Cold radiators or inconsistent heat
• -Visible rust and corrosion on unit
• -Spiking gas bills

What's Included

• -Remove and haul away old boiler
• -Install new boiler unit
• -Connect to existing piping
• -Gas line reconnection
• -Expansion tank check or replacement
• -Pressure test, startup, and balancing

Hiring an HVAC Contractor in Dallas

• 1.Verify the contractor holds a current TX HVAC license and carries liability insurance.
• 2.Request an itemized quote that separates equipment, labor, and permit costs.
• 3.Ask specifically about American Standard dealer status — authorized dealers in Dallas, TX often offer extended warranties.
• 4.Confirm the quote includes refrigerant, line set, and startup commissioning — not just the equipment.
• 5.Check for manufacturer rebates and utility company incentives before signing.

Frequently Asked Questions