Furnace Installation Cost in Madison, WI
Carrier 1.5-Ton 16 SEER

The average cost of furnace installation in Madison, WI with a Carrier 1.5-ton 16 SEER system is $3,270, with most homeowners paying between $3,060 and $3,480 depending on home conditions, permit fees, and labor availability. The Carrier 1.5-ton unit is a trusted mid-range system balancing cost, efficiency, and durability, sized for homes with under 600 sq ft of conditioned space. At 16 SEER, this unit meets current federal minimum standards with reliable performance at an accessible price point.

Cost Breakdown - Madison, WI

* Estimates based on Madison area labor rates ($104.74-$170.02/hr, BLS-sourced). Actual costs vary by home conditions and contractor. Get 3 quotes.

About Furnace Installation

Complete replacement or new installation of a gas or electric furnace including ductwork connections, venting, gas line, and thermostat. In Madison, WI, licensed HVAC contractors typically charge $105–$170 per hour for installation labor, with this job averaging 6 hours.

The equipment cost for the Carrier 1.5-ton 16 SEER system represents approximately $2,000 of your total. Installation labor in Madison adds $820, with permit fees, refrigerant, and disposal bringing the full estimate to $3,270. Prices in WI vary by contractor — always collect 3 quotes before scheduling a major HVAC installation.

Signs You Need Furnace Installation

Consider scheduling furnace installation in Madison, WI if you notice furnace over 15-20 years old or frequent costly repairs or uneven heating room to room. Early action prevents the costly emergency service premiums common in the Midwest region during peak seasons.

• -Furnace over 15-20 years old
• -Frequent costly repairs
• -Uneven heating room to room
• -Rising heating bills despite mild weather
• -Yellow or flickering burner flame

What's Included

• -Remove and haul away old furnace
• -Install new furnace unit
• -Connect to existing ductwork
• -Gas line or electrical connections
• -Flue and venting installation
• -Thermostat setup and testing

Hiring an HVAC Contractor in Madison

• 1.Verify the contractor holds a current WI HVAC license and carries liability insurance.
• 2.Request an itemized quote that separates equipment, labor, and permit costs.
• 3.Ask specifically about Carrier dealer status — authorized dealers in Madison, WI often offer extended warranties.
• 4.Confirm the quote includes refrigerant, line set, and startup commissioning — not just the equipment.
• 5.Check for manufacturer rebates and utility company incentives before signing.

Frequently Asked Questions